Hello Guest
« previous next »
Pages: [1]   Go Down

such a newb question im embarassed

  • 2 Replies
  • 1208 Views

0 Members and 2 Guests are viewing this topic.

*

Offline jessekvfd

  • 11
  • 0
  • Gender: Male
such a newb question im embarassed
« on: April 15, 2012, 06:24:39 PM »
  Putting my ome rear springs on. the nut for the locating pin doesn't fit the hole in the center of the plate the u-bolts go through. So I am guessing the nut comes off plate goes on then nut back on? there is no washer on the nut now should I put one on? The old stuff was so rusted I had to use a grinder and bfh to get it all apart and didn't pay attention well enough I guess. thanks.
Logged
*

Offline mrfuelish

  • *
  • 2862
  • 13
  • Gender: Male
  • you must have a perception problem.
Re: such a newb question im embarassed
« Reply #1 on: April 15, 2012, 09:18:52 PM »
I would either take the bolt out and turn it over or grind down the out side of the nut a little to get it to fit the hole.
Logged
1987,1988,1988,1990 samurai's,  1953 m38a1,  1996 x-90,blue.1996 x-90 red.1994 2 door tracker.   only Dead Fish go with the flow.                No Hairy Nosed Wombats were ran over on the trail today.       My ZUK is Xenophobic.
*

Offline Boxcar

  • 936
  • 34
  • Gender: Male
Re: such a newb question im embarassed
« Reply #2 on: April 20, 2012, 09:14:44 AM »
SPUA or SPOA????
...Boxcar...
Logged
God Bless
88.5 Samurai Heavily modified.
Pages: [1]   Go Up
« previous next »