Hello Guest
« previous next »
Pages: [1]   Go Down

Slip Yoke Eliminator bolt pattern??

  • 2 Replies
  • 926 Views

0 Members and 4 Guests are viewing this topic.

*

Offline SIDEKICK65

  • 176
  • 0
  • Gender: Male
Slip Yoke Eliminator bolt pattern??
« on: October 30, 2012, 09:55:33 PM »
I got my t case to day with the 4:24:1 gear's :) It came with the Slip Yoke Eliminator that has double bolt pattern.so what im asking is what the bolt pattern fit's.I was going to have a drive line made and needed to know.
Logged
*

Offline talonxracer

  • 1284
  • 34
Re: Slip Yoke Eliminator bolt pattern??
« Reply #1 on: October 31, 2012, 06:32:30 AM »
they are the small and large pattern Sami bolt patterns
Logged
Tim "the toolman" Taylor is my HERO !!!

The only GOOD Commie is the commie taking a dirt nap....
*

Offline mrfuelish

  • *
  • 2862
  • 13
  • Gender: Male
  • you must have a perception problem.
Re: Slip Yoke Eliminator bolt pattern??
« Reply #2 on: October 31, 2012, 10:02:26 AM »
you could pick up a 1990 samurai or newer front or rear drive line and have the tube made to order. I think it is the same pattern for toyota but the hole in the center is a tiny bit larger than a sammie. not sure what you have, take it by walker an see if he has one laying around.
Logged
1987,1988,1988,1990 samurai's,  1953 m38a1,  1996 x-90,blue.1996 x-90 red.1994 2 door tracker.   only Dead Fish go with the flow.                No Hairy Nosed Wombats were ran over on the trail today.       My ZUK is Xenophobic.
Pages: [1]   Go Up
« previous next »