Hello Guest

Front Diff Actuator 2000 GRAND V

  • 3 Replies
  • 1405 Views

0 Members and 4 Guests are viewing this topic.

*

Offline specjockey

  • 5
  • 0
  • I love YaBB 1G - SP1!
Front Diff Actuator 2000 GRAND V
« on: February 10, 2006, 11:27:50 PM »
Can anyone tell me what the air pressure should be when the 4WD is activated? I get a loud clunking in the front left axel when making sharp corners in 4WD. I have already had to change the carrier because of the right side seal failure. The clunk was there before. I thought with the entire front diff replacement (Used), the problem would be solved. I have tried another actuator but the pressure is the same. About 4-5 lbs. Is it possible that it could be the letf outer CV? The noise is only there in 4WD.

*

Offline the_maplebar

  • 466
  • 0
  • Gender: Male
Re: Front Diff Actuator 2000 GRAND V
« Reply #1 on: February 11, 2006, 08:48:46 PM »
The CV's are always spinning on these (unless you have installed manual hubs).  You could always get rid of the diff actuator.

http://www.zukiworld.com/month_030104/feature_tsb_shiftontheflyremoval.htm
2002 4DR Tracker V6 ZR2.... 1.5"/2" coil spacers front/rear, BDS Strut Extensions, 235/75R15 Cooper STT... They ROCK!!!
http://www.zukiworld.com/forum/index.php?topic=35.msg111575#msg111575[/url]

*

Offline 97TRAKIN

  • 600
  • 0
  • Gender: Male
  • Suzuki in Chevy clothing.
Re: Front Diff Actuator 2000 GRAND V
« Reply #2 on: February 12, 2006, 08:36:35 AM »
In 4X4 when making tight turns especial on hard surfaces (wet or dry) you WILL get a metalic clucking noise from the CVs
it's normal. ;)  89-98 vehicles didn't do this though, at least mine didn't.

*

Offline sergi

  • 307
  • 0
  • Gender: Male
Re: Front Diff Actuator 2000 GRAND V
« Reply #3 on: February 14, 2006, 12:56:26 AM »
The pressure should be 30-45 kPa. That is 4,3-6,5 pounds/sq inch.  ;)
Suzuki Grand Vitara 3dr TurboDiesel
Barcelona, Europe
Aquesta és la meva màquina. Creus que em pots seguir?