Quote from: Mikerpm4x4 on September 12, 2006, 09:59:52 PM

. Im not sure how you would set up antidive. The arms are parellel and I have not had any issues with wheel bearings.

Mike

 if the upper arm mounts are sloped to the rear a bit you get anti dive.

 So your arms are parallel, I can do that.

 Thanks for being so open with info.
Pat

I'm assuming you mean fron to back slope... In his write-up, he says the upper a-arms(calmini a-arms) are mounted in the stock location for the lower a-arms, so if the stock a-arms are parallel, then his would be - right?

ive followed this thread from here to pirite and i , give you mad props ,that thing is sweet

hey mike do you have any more action or trail vid pics or anything and how has it been going any issues come up???

I have a couple pics that Ive been hanging on to. Eric and I have been disscussing a followup. Im leaning twards just starting a thread about it. Either way you will see it soon.

Mike

 Mike what taper are the ball joints? They look almost like a morse taper.

Mike what taper are the ball joints? They look almost like a morse taper.

  I have no Idea! My freind Stan has a lot of cool tools/machines in his garage. He had a bore with the right tapper.

Mike

Quote from: mudpuppy on September 19, 2006, 12:58:08 PM

Mike what taper are the ball joints? They look almost like a morse taper.

  I have no Idea! My freind Stan has a lot of cool tools/machines in his garage. He had a bore with the right tapper.

Mike

Next time you see him could you ask him?
Pat

I hate to answer my own posts but it seems to be 1.5 inch per foot taper. As measure by an excellent machinist here at work.
Pat

I hate to answer my own posts but it seems to be 1.5 inch per foot taper. As measure by an excellent machinist here at work.
Pat

For thoes of us who don't know(well,... me) could you explain what this is, and what this info could be used for?
Also: Mike's friend, Stan is a member here, his username is "37kicker" so you could always send him a PM to find out for sure.

yes we used a1.5 tapered ream for the ball joint.   stan