Im doing an engine swap because the old one was just getting old but anyways when i put the distributor in where are the points suppossed to be?

probably not if it wasn't marked...

check the book if you got one. TDC of piston #? and the rotor should point to that piston. I can't remember if it's #4 or #1 but someone will probably post.

I figured it out by myself but its (1-3-4-2) and the roter spins counter clockwise.

I figured it out by myself but its (1-3-4-2) and the roter spins counter clockwise.

10-4!

I figured it out by myself but its (1-3-4-2) and the roter spins counter clockwise.

That is true if you are swapping in a 16V.  If you are swapping in an 8V the disty spins clockwise.

Quote from: Taymer on March 09, 2010, 05:59:15 PM

I figured it out by myself but its (1-3-4-2) and the roter spins counter clockwise.

That is true if you are swapping in a 16V.  If you are swapping in an 8V the disty spins clockwise.

Confusing but true!