Here is the deal , I have a 94' track that I doing and a 89' sidekick for parts. The 94' needed a new ignition switch so i took the assy out of the 89 and put it into the 94. The 94' is a 5 speed and the 89' is an auto. So, I had to wire the small lever on the good assy so the switch would turn far enough because of the auto safety. Now, I put the old switch assy into the 89' . It will light up all the dash lights but will not turn the starter over. what do I have to jump or hookup so I can get this out of my shop ? I know it will be able to start in gear but I will be careful and this will not be driven on the road. It is just going to go in and out of the shop while i am stripping parts off of it.
What do I need to jump or hookup besides the main big harness clip that goes to the switch /
Thanks,
Raz