Hello Guest
« previous next »
Pages: [1]   Go Down

TT Undertaker

  • 5 Replies
  • 1058 Views

0 Members and 1 Guest are viewing this topic.

*

Offline blacktrack99

  • *
  • 254
  • 2
  • Gender: Male
TT Undertaker
« on: October 08, 2012, 10:37:52 PM »
After a phenomenal run in Johnson Valley on Saturday (despite the driver being grossly out of practice), I asked the Mrs. what the next mod to the BlackTrack would be.  I assumed she'd say front bumper since the rear was just done, and the plastic front cover took quite a bashing on Saturday (refer back to the driver being grossly out of practice).  I was planning on steel front carrier and locking front diff, but she says, "Let's save up a little for the underdrive so we can push 33's in the near future."  That gal's a keeper.   ;D
Logged
*

Offline nprecon

  • 2318
  • 52
  • Gender: Male
  • ONWARD... through the fog!
Re: TT Undertaker
« Reply #1 on: October 08, 2012, 10:56:01 PM »
You just HAFTA love special women like that!   She's a keeper!   For sure!
Logged
'02 Chezuki Tracker with a 2 Liter and 5spd.  It works for me!!!
*

Offline 3stagevtec

  • 204
  • 3
  • Gender: Male
  • killing two stones with one bird...
Re: TT Undertaker
« Reply #2 on: October 11, 2012, 08:08:47 PM »
1) A keeper for sure!

2) I thought the Undertaker cannot work on the 2nd gen GVs.. Something about the output shafts being the wrong diameter / spline count?? (I had emailed TT a while back and was told that.. I wonder where that mail went)
Logged
*

Offline blacktrack99

  • *
  • 254
  • 2
  • Gender: Male
Re: TT Undertaker
« Reply #3 on: October 16, 2012, 03:54:25 PM »
Not sure.  I remember emailing them a while back (before my wheelin' got sidetracked) and being told it was compatible.   ???  I may have to rethink things again...
Logged
*

Offline BRD HNTR

  • 2300
  • 56
  • Gender: Male
Re: TT Undertaker
« Reply #4 on: October 16, 2012, 04:52:28 PM »
The earlier XL7's have a smaller output shaft then the 2005 XL7.  When I got an early case (after dropping mine on garage floor) I was able to change the output shaft to the larger one.
Logged
93 Tracker,XL7 springs & 1" raised spring pads in front with YJ springs in back, home built bumpers rear & front (w/winch), 2" x 4" rock tubes,  ARB front & rear, converted Sami rear to IFS, 33x12.5x15  aluminum rims, roll cage, 2.7L w/5 speed auto.
*

Offline jason hutchison

  • 495
  • 5
  • Gender: Male
  • ZUKIWORLD Staff
    • ZUKIWORLD Online
Re: TT Undertaker
« Reply #5 on: October 20, 2012, 11:09:43 PM »
Quote from: blacktrack99 on October 08, 2012, 10:37:52 PM
After a phenomenal run in Johnson Valley on Saturday (despite the driver being grossly out of practice), I asked the Mrs. what the next mod to the BlackTrack would be.  I assumed she'd say front bumper since the rear was just done, and the plastic front cover took quite a bashing on Saturday (refer back to the driver being grossly out of practice).  I was planning on steel front carrier and locking front diff, but she says, "Let's save up a little for the underdrive so we can push 33's in the near future."  That gal's a keeper.   ;D

Ha Ha yeah Johnson valley does that for some reason. We went on the tinbender jamboree and ran aftershock 2yrs ago.. After that run the mrs oked new shocks more lifts and 35s for the tracker. congrats on the green light and keep me posted if your going wheelin. We are close by.

Hutch
Logged
Pages: [1]   Go Up
« previous next »