Hello Guest
« previous next »
Pages: [1]   Go Down

need help

  • 5 Replies
  • 1095 Views

0 Members and 1 Guest are viewing this topic.

*

Offline ldodge92

  • 107
  • 2
  • Gender: Male
need help
« on: September 28, 2012, 11:24:01 AM »
Got question prob a stupid one. just put my first motor(1.6 8v auto) back in. forgot the metal gasket/dust guard that goes between the bell housing and block. is this gonna be a problem?
Logged
My new addiction
*

Offline Drone637

  • *
  • 8121
  • 116
  • Gender: Male
  • Evil Cow
Re: need help
« Reply #1 on: September 28, 2012, 11:43:28 AM »
Do you mean the guard that goes on the bottom to keep dirt out from getting into the bell housing?
Logged
96 Geo Tracker, x-SJ-410,  x-White Rabbit, x-Project Trouble
Crawlers NorthWest
x-Trouble Racing
*

Offline jzap

  • 515
  • 2
  • Gender: Male
  • How difficult can it be?
Re: need help
« Reply #2 on: September 28, 2012, 07:36:06 PM »
The most likely problems you  may run into are a chewn up starter drive from dirt getting into it as well as starter failure from dirt in the bearings.  You might also get dirt into the rear main seal and open up an oil leak.
Logged
Jim Z.
96 Tracker
66 Apache camper
*

Offline Pest!

  • 52
  • 1
  • Gender: Male
  • on the road again
Re: need help
« Reply #3 on: September 29, 2012, 11:49:58 AM »
water and mud on your throw out bearing . dirt in the clutch and a wet clutch faster when in deep water.  :-X
Logged
88.5 Samurai,1.6L 16V Tracker obdII, Calmini reversal with 5" lift., Bushwackers, Rockrawler wheels w 33" 1050/15 BFG KM2s  ,TC. Bumpers, Lockers,  4.16 Tcase, power steering , oversize fuel tank, Warrior Rack
Bob
*

Offline WesP

  • 40
  • 3
Re: need help
« Reply #4 on: September 29, 2012, 08:05:06 PM »
Bite the bullet and put it in. It can be slipped in by sliding the trans back a bit.
Logged
*

Offline Skyhiranger

  • 3734
  • 122
  • I don't buy, what I can build
Re: need help
« Reply #5 on: September 30, 2012, 09:22:08 AM »
Sounds like he might be talking about the upper spacer, not the lower dust shield. 
The spacer also locates/stabilizes the starter.  I would slide the tranny back and install the spacer, if it were me.
Logged
Tracker and Sidekick parts for sale.....PM me with your wants/needs.
Pages: [1]   Go Up
« previous next »