Hello Guest
« previous next »
Pages: [1]   Go Down

Fixed Rockers

  • 8 Replies
  • 1692 Views

0 Members and 1 Guest are viewing this topic.

*

Offline efalk

  • 14
  • 0
  • Gender: Male
Fixed Rockers
« on: July 05, 2009, 08:49:34 PM »
I finally fixed my rockers!
Logged
*

Offline Rileysowner

  • 39
  • 0
  • Gender: Male
Re: Fixed Rockers
« Reply #1 on: July 06, 2009, 06:27:18 AM »
Looks good.  So what did you use to replace the rocker? 
Logged
*

Offline efalk

  • 14
  • 0
  • Gender: Male
Re: Fixed Rockers
« Reply #2 on: July 06, 2009, 06:35:48 AM »
A company called cross Canada supplied the rockers. 
The only down side was the replacement rocker panels had a square edge where as the sidekick has a round edge.  It took a little hammering on the kick to flatten it out.
Logged
*

Offline sir lance

  • 342
  • 4
  • I love my XL-7
Re: Fixed Rockers
« Reply #3 on: July 06, 2009, 09:52:15 AM »
is it a thick material? ive seen guys weld in a 2x3 1/4 wall and turn the rockers into high Clarence rock sliders....works well

looks good man........


-Lance
Logged
02' XL-7 1 Ton axles, dual t-cases 37's etc......
Trucks are built not bought*********
*

Offline efalk

  • 14
  • 0
  • Gender: Male
Re: Fixed Rockers
« Reply #4 on: July 07, 2009, 03:12:23 PM »
No its not that thick. 

Its about 3/16 inch sheet metal.
Logged
*

Offline Rileysowner

  • 39
  • 0
  • Gender: Male
Re: Fixed Rockers
« Reply #5 on: July 07, 2009, 03:40:17 PM »
I have them in my bookmarks on my browser. 
Logged
*

Offline Uncivilized

  • 1469
  • 1
  • Gender: Male
    • Car Domain
Re: Fixed Rockers
« Reply #6 on: July 07, 2009, 05:11:31 PM »
Good stuff ;)

Any sheetmetal shop can bend these too. Make a bend template for them using a piece of metal coathanger, and give them the length.
Logged
*

Offline sheri

  • 8
  • 0
Re: Fixed Rockers
« Reply #7 on: July 07, 2009, 10:32:34 PM »
Nice job!!  You did the plug welds and everything like factory!! 
Logged
*

Offline efalk

  • 14
  • 0
  • Gender: Male
Re: Fixed Rockers
« Reply #8 on: July 08, 2009, 09:22:14 AM »
Yep, I ground the welds down, filled the empty space with seam sealer and sanded it all flush.  After that is was three coats of rocker guard.
Logged
Pages: [1]   Go Up
« previous next »