Hello Guest
« previous next »
Pages: [1]   Go Down

T-case rear output bearing???

  • 5 Replies
  • 1282 Views

0 Members and 1 Guest are viewing this topic.

*

Offline ppltrak

  • 654
  • 0
  • Gender: Male
  • zukspeed staff
    • zukspeed.com
T-case rear output bearing???
« on: August 22, 2008, 01:29:12 PM »
I need to replace the output bearing on a 93 kick. The yoke and bearing have gave up the ghost. Can I just remove the back part of the T-case and press out the bearing, then do the opposite to install? Or do I have to remove the whole case and split it on the bench. Any help would be great.

    Thanks
     Kevin
Logged
94 purple/green splash tracker w/ calmini 3' heavly modified lift 32 11.5 r15 bfg m/t's  & custom air induction and header w/ 2"exh. no cat lockrite rear 2" B/L and a heavy right foot and now 583s steel up front and locked.
2002 GV 2.5l 4.5 ZN lift locked on 31's
*

Offline RHodge

  • 523
  • 0
  • Gender: Male
Re: T-case rear output bearing???
« Reply #1 on: August 22, 2008, 02:09:43 PM »
I've always found it easer to take something out rather then laying on my back trying to fix it.


Ryan 

Logged
*

Offline ppltrak

  • 654
  • 0
  • Gender: Male
  • zukspeed staff
    • zukspeed.com
Re: T-case rear output bearing???
« Reply #2 on: August 22, 2008, 02:10:50 PM »
I have a lift ;)

  Kevin
Logged
94 purple/green splash tracker w/ calmini 3' heavly modified lift 32 11.5 r15 bfg m/t's  & custom air induction and header w/ 2"exh. no cat lockrite rear 2" B/L and a heavy right foot and now 583s steel up front and locked.
2002 GV 2.5l 4.5 ZN lift locked on 31's
*

Offline J-Ron

  • 50
  • 0
  • Gender: Male
  • when in doubt, straighten it out
Re: T-case rear output bearing???
« Reply #3 on: August 22, 2008, 09:33:07 PM »
I recently did the 6.5 : 1 t-case gears and i believe the rear output bearing is impossible to get out without dropping the entire t-case. cause the output assembly has a snap ring holding it together and i needed a hydraulic press to get the bearings off.

here's a pretty good illustration http://trail-gear.com/tech/zuk65gears/index.html
Logged
*

Offline mrfuelish

  • *
  • 2862
  • 13
  • Gender: Male
  • you must have a perception problem.
Re: T-case rear output bearing???
« Reply #4 on: August 22, 2008, 10:06:37 PM »
I think he is talking about a tracker t case, it has a needle bearing that has to be pulled from the back.
Logged
1987,1988,1988,1990 samurai's,  1953 m38a1,  1996 x-90,blue.1996 x-90 red.1994 2 door tracker.   only Dead Fish go with the flow.                No Hairy Nosed Wombats were ran over on the trail today.       My ZUK is Xenophobic.
*

Offline J-Ron

  • 50
  • 0
  • Gender: Male
  • when in doubt, straighten it out
Re: T-case rear output bearing???
« Reply #5 on: August 23, 2008, 11:51:22 AM »
well it's all greek to me then....
Logged
Pages: [1]   Go Up
« previous next »