Hello Guest
« previous next »
Pages: [1]   Go Down

T-case flange question

  • 4 Replies
  • 1299 Views

0 Members and 1 Guest are viewing this topic.

*

Offline cuban_b

  • 38
  • 0
  • Gender: Male
  • shop smart, shop S-mart
T-case flange question
« on: May 05, 2005, 03:02:38 PM »
Is the t-case output flange interchangeable with the axle pinion flange?
Logged
*

Offline Natebert

  • 1098
  • 0
  • Gender: Male
Re: T-case flange question
« Reply #1 on: May 05, 2005, 03:22:01 PM »
Don't think so on Sammy or Sidekick
Size/Spline differences on Sammy.  (bolt pattern should be the same)

And on a kick one is a slip, where the other isn't.

~Nate
« Last Edit: May 05, 2005, 03:41:53 PM by natebert »
Logged
*

Offline cuban_b

  • 38
  • 0
  • Gender: Male
  • shop smart, shop S-mart
Re: T-case flange question
« Reply #2 on: May 05, 2005, 03:39:59 PM »
On a samurai, I probably should have mentioned that.  The flange appears to be the same size, but are the splines different?
Logged
*

Offline cuban_b

  • 38
  • 0
  • Gender: Male
  • shop smart, shop S-mart
Re: T-case flange question
« Reply #3 on: May 07, 2005, 09:10:54 AM »
any help would be appreciated.
Logged
*

Offline rockrat

  • 196
  • 0
  • Gender: Male
  • Got Ringr
Re: T-case flange question
« Reply #4 on: May 10, 2005, 09:37:55 AM »
I think either the front input or output was the same, I know the rear out is different length.
Logged
Pages: [1]   Go Up
« previous next »