Towing a geo without engine battery or ignition switch

kody

11
0

Towing a geo without engine battery or ignition switch

« on: December 02, 2011, 11:24:21 AM »

How do I tow a geo without engine or electric

Logged

mrfuelish

2862
13
Gender:
you must have a perception problem.

Re: Towing a geo without engine battery or ignition switch

« Reply #1 on: December 02, 2011, 11:31:46 AM »

With a tow Bar.

Logged

1987,1988,1988,1990 samurai's, 1953 m38a1, 1996 x-90,blue.1996 x-90 red.1994 2 door tracker. only Dead Fish go with the flow. No Hairy Nosed Wombats were ran over on the trail today. My ZUK is Xenophobic.

kody

11
0

Re: Towing a geo without engine battery or ignition switch

« Reply #2 on: December 02, 2011, 12:26:54 PM »

I have a tow bar. Do I need to disconnect anything on the geo

Logged

mrfuelish

2862
13
Gender:
you must have a perception problem.

Re: Towing a geo without engine battery or ignition switch

« Reply #3 on: December 02, 2011, 05:31:45 PM »

I would pull the rear drive shaft if your going long distance, but if you have a transfers case and transmission in it just take a strap for a motorcycle and pull the front of the trans up where it would normally be and put the transfer case in neutral and you should be OK I towed one like that for a couple of hundred miles.

Logged

1987,1988,1988,1990 samurai's, 1953 m38a1, 1996 x-90,blue.1996 x-90 red.1994 2 door tracker. only Dead Fish go with the flow. No Hairy Nosed Wombats were ran over on the trail today. My ZUK is Xenophobic.