Hello Guest
« previous next »
Pages: [1]   Go Down

Machining Sammi diff for Tracker install?

  • 0 Replies
  • 1075 Views

0 Members and 1 Guest are viewing this topic.

*

Offline BRD HNTR

  • 2300
  • 56
  • Gender: Male
Machining Sammi diff for Tracker install?
« on: December 16, 2008, 11:32:58 AM »
When machining a Sammi diff. for a tracker install, do you machine the passenger side bearing sleeve to the same depth as the sleeve in the Tracker diff.?  I would assume so, but do not want to guess at this point.
Logged
93 Tracker,XL7 springs & 1" raised spring pads in front with YJ springs in back, home built bumpers rear & front (w/winch), 2" x 4" rock tubes,  ARB front & rear, converted Sami rear to IFS, 33x12.5x15  aluminum rims, roll cage, 2.7L w/5 speed auto.
Pages: [1]   Go Up
« previous next »