ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: de Ploeteraar on December 15, 2005, 02:39:51 AM

Title: custom made rollcage mounting points
Post by: de Ploeteraar on December 15, 2005, 02:39:51 AM

Hello,

I try to made a homemade rollcage but i need ideas about the mountingpoints to the car. Maybe pictures will help. I will place one tube behind the seats on the floor. But how mounting that on the floor? And place two tubes from the basic tube (behing the seats) to the back side. How can i mounting that?

Thanks. ::)

Title: Re: custom made rollcage mounting points
Post by: dave on December 15, 2005, 10:04:18 AM

You wil have to make round plates to squize your body between it.

Title: Re: custom made rollcage mounting points
Post by: rockrat on December 15, 2005, 04:33:01 PM

another way, run a tube across the floor picking up the stock seat belt holes. The tube must be drilled and sleeved so it does not crush. Then do as in pic below
(http://photos.zuwharrie.com/users/rockrat/pass_side_rear_cage_mount.JPG)

(http://photos.zuwharrie.com/users/rockrat/Rear_dr_side_mount_IMG.jpg)