Hey everybody.
I got a crawler style bumper for my Zuki.
It uses the grote sealed lights in the rear.
My question is how to correctly wire them.
There are five in all.
4 red and a white b/u

I have researched the suzuki wire color/function but am unsure of where to connect them to these lights.
It must be simple, I see 6" oval lamps in just about every tractor/trailer around here.

The new pigtails have three leads on them.
White with a hoop connector, red, and black.

Any help on how to do this.
I am wiring retarded so if you could speak in laymans term it would help.
Thanks for any info.

You need a diode box ( trailer towing box for six lights into four lights or import to domestic lights) not too hard to do just get a test light and follow instructions.

So if I understand you correctly I have to buy a trailer diode box?
I cannot connect the pigtail to my existing Zuki wiring?

I know virtually nothing about wiring.
I thought it would be simple. 

No trailer wiring adapter needed.  That would be required if you were going from the 4 light system that suzukis have (not counting the reverse light) to a 2 light system of a trailer (having a dual filament bulb for brake/running/turn lights on each side).  In this case you are going from 4 lights to 4 lights so no conversion.  Have a read through here and this should answer your questions: http://www.izook.com/tech/samurai/bumper/shrockrearbumper/rearbumper2.htm 

Precisely what I was looking for.

Thanks very much for taking the time Ian.

Saved me a wild goose chase and shows me exactly what I needed to know with pics.

The Suzuki Gods are smiling down on you.   

ya but they don't look near as cool as four brake lights and two turn signal lights, you need all the help you can get around here.