Hello Guest
« previous next »
Pages: [1]   Go Down

Rear Diff Question

  • 5 Replies
  • 1737 Views

0 Members and 3 Guests are viewing this topic.

*

ultra-rebel

Rear Diff Question
« on: February 13, 2008, 07:54:23 AM »
I pulled the rear diff to weld er up and it looks like a limited slip diff. There are no visible side gears like other diffs I have taken apart and I dont want to disassemble if I dont have to.

Can someone tell me if this is in fact a LS or do I have to pull it apart to get at and weld the gears

Logged
*

Offline Mikerpm4x4

  • 2875
  • 12
  • Gender: Male
  • Redline... all the time!
    • www.rpm4x4.com
Re: Rear Diff Question
« Reply #1 on: February 13, 2008, 10:39:16 AM »
This is a standard diff. I can see the side gears in the photos. The spiders are webbed which is why it looks funny to you. I wouldnt dissasemble the diff to weld it. I just weld what I can see in the windows and call it good. Its always worked for me.
Logged
If your not living life to the fullest then your not living at all.

You wont really know if your wrong till your upsidedown
*

ultra-rebel

Re: Rear Diff Question
« Reply #2 on: February 13, 2008, 12:14:08 PM »
Thanks Mike I'll try welding it through the windows this weekend.
Rebel
Logged
*

ultra-rebel

Re: Rear Diff Question
« Reply #3 on: February 21, 2008, 10:26:41 PM »
I welded er up and she works fine so far......  Thanks guys
Logged
*

big_kountry21

Re: Rear Diff Question
« Reply #4 on: February 21, 2008, 11:00:28 PM »
was it hard to weld?
Logged
*

ultra-rebel

Re: Rear Diff Question
« Reply #5 on: February 22, 2008, 07:08:59 AM »
No,  after removing the diff there are four 1" windows.  I just cranked up the old Lincoln and welded the dff through the windows.
I did however find that welded diffs on ice are very scary on these little trucks. I dont think I would do it on my DD
Logged
Pages: [1]   Go Up
« previous next »