Hello All,

I just put new clutch in my 90 Tracker..the reverse lights not working.Not sure if they were working before swap.When I pulled the tranny I disconnected the harness near the intake.I checked the fuses,bulbs,and the harness connector.where on the tranny is the "switch" for the back-up lights.Any help would be great.Went to get a sticker and they FAILED it because of back up lights..So it's got to be fixed,Can't find crap in my Haynes manual.

Thanks Tom K.

there's a little switch on the tranny for the reverse lights.. check there some times it sticks

OK,

Where at on the tranny?? Is it near the shifter.I looked today and didn't see it.Never thought to look when tran was out. Put it right back after cleaning the flywheel and changing bearings etc.Was not looking at switch for problems etc.

Thanks Tom K.

open the hood and look down on top of the tranny should be 2 wires comming out from it,, kindof a bitch to get at but thats where it's at,, i think it's like a 21 or 22 mil nut .. hope that helps