I have the Baja Body all striped & ready to remove (just the steeting is hooked up so i can move it around)
so now ill have to rangle up some help removing it at some point.

Still tinkering with the samurai & trying to gather some more parts before I get it tore down.
got 1 front wheel repacked & the studs replaced need to do the other side still (got to wate till I can get the studs befor I tare it apart). & going to get the suspention all done before I remove the body.
Oh, & I bought a set of wheels for my 31x10.5's

Cool project. I registered to the site so I could subscribe to the thread. Let me know if you have any questions.
I would be glad to help where I can.

Im sure Ill have some more questions.

& When i get it all finished you can check it out in person if you want.   I still come back to the seattle aria  about  once a year. (i grew up there.) My best friend lives in Puyalup & I have relatives all over up there as well.

Haven't made any actual progress, but:
Got the 31x10.5 on the new wheels.
 Picked up a full sidekick power steering set-up,  rear seat.
 Got a set of YJ springs.

probably forgetting some stuff.

Just need to start selling off all my other toys so I can aford to get the trailtough YJ suspension kit, 4 speed auto trans  & other parts needed,  so I can actualy start working on this thing.

made a bit of progress....

Finaly got  some YJ brackets made so I could get started on this thing. Used a template I found on line.  But after making them all & then test fitting 1, I kindof wish I would have done them differantly (oh well they will work for now).  

If anyone want a set I could get a set made for around $50  (might be a bit less)  they are cut on a C&C plaz table.



Still need to figure out what to do for shackles.  any sugestions?

Jeep Cherokee rear shackles?