Hello Guest
« previous next »
Pages: [1]   Go Down

How do you take the body clading off of a Tracker?

  • 4 Replies
  • 1197 Views

0 Members and 1 Guest are viewing this topic.

*

Offline AJMBLAZER

  • 2166
  • 1
  • Your mom.
How do you take the body clading off of a Tracker?
« on: September 02, 2006, 06:24:54 PM »
I'm talking about the anti-door ding trim stuff about half way up the doors and fenders at the body line on the mid-90's models.  Seen here:


With any luck I'll be Chassis Saver'ing the rust and then Herculining at least up to the body line and anywhere else I have rust soon.

These held on by 3M tape?
Logged
*

Offline HotRod

  • *
  • 4334
  • 2
  • Gender: Male
  • 95 Tracker
    • cardomain.
Re: How do you take the body clading off of a Tracker?
« Reply #1 on: September 02, 2006, 06:31:20 PM »
heat and peel.
I'd wait for Sunny day tho. ;D
Logged
95 2dr Geo Tracker with Calmini 6"inch combo lift, 32'inch BFGs M/Tlocked and loaded--D.D is my 06 Racy RED Aerio SX AWD
*

Offline AJMBLAZER

  • 2166
  • 1
  • Your mom.
Re: How do you take the body clading off of a Tracker?
« Reply #2 on: September 02, 2006, 07:11:32 PM »
Like the next week? :P

Heat gun type heat or would a hair dryer work?
Logged
*

Offline Carnage

  • 2453
  • 0
  • Gender: Male
  • If you only knew the POWER...
Re: How do you take the body clading off of a Tracker?
« Reply #3 on: September 02, 2006, 07:15:47 PM »
I just used the Hawaiian Sun and a razorblade on mine

cleaned up the gum with paint thinner

(didnt worry too much as I was going to be painting it anyway)

least there were no holes to plug

Logged
*

Offline AJMBLAZER

  • 2166
  • 1
  • Your mom.
Re: How do you take the body clading off of a Tracker?
« Reply #4 on: September 02, 2006, 07:33:57 PM »
Eh, as long as the crap left over isn't too thick or noticeable I'll probably just clean as much of it off with Xylol as possible and then Herculine over it. 8)
Logged
Pages: [1]   Go Up
« previous next »