Hello Guest
« previous next »
Pages: [1]   Go Down

2000 Tracker rear third in 96 Tracker

  • 1 Replies
  • 1114 Views

0 Members and 1 Guest are viewing this topic.

*

Offline joe_and_jeep

  • 116
  • 0
  • Gender: Male
  • Why have a Rev Limiter and not use it?
2000 Tracker rear third in 96 Tracker
« on: April 10, 2007, 08:52:49 AM »
I got a 4.875 rear axle (complete) out of a 2000 Tracker.  I'm putting it in my 1996 Auto Tracker to replace my 4.30s and match my front CJ axle.  I haven't picked up the axle yet.  Does the 2000 Wacker third have the holes to mount my upper control arm?  Or should I just pull the gears and swap them in my 96 third member?

I was also thinking about just 4linking the rear of my Tracker but I wanna get this done efficiently as possible considering I haven't even started putting my front axle in yet.
Logged
96 Tracker DD - 2in, 30s
95 Tracker Under the Knife - 4.3V6 - Rest Unknown
91 Jeep YJ Full Cage, Tri Link, D44/D44 35s
84 Jeep XJ Doubler HP44/9IN 35s
*

Offline Yankee-Tim

  • 562
  • 1
Re: 2000 Tracker rear third in 96 Tracker
« Reply #1 on: April 18, 2007, 01:58:12 PM »
Quote from: joe_and_jeep on April 10, 2007, 08:52:49 AM
I got a 4.875 rear axle (complete) out of a 2000 Tracker.  I'm putting it in my 1996 Auto Tracker to replace my 4.30s and match my front CJ axle.  I haven't picked up the axle yet.  Does the 2000 Wacker third have the holes to mount my upper control arm?  Or should I just pull the gears and swap them in my 96 third member?

I was also thinking about just 4linking the rear of my Tracker but I wanna get this done efficiently as possible considering I haven't even started putting my front axle in yet.

No 3 link mount on the GV diff, as the GV/TrackerII is a 4link suspension.  Sorry.
Logged
Pages: [1]   Go Up
« previous next »